Ball-ends, in corrosion-resistant steel, swaged on aircraft control wire rope. Dimensions and loads1 Scope This International Standard specifies the characteristics of ball ends in corrosion resistant steel swaged on aircraft control wire rope.

BS EN 13029 specifies the dimensions and profile of the aperture for Type A and Type B plug-in plastic closures used in round and non-round metal containers of nominal wall thickness equal to or less than 0

017 and intercepts y = + 0

Sampling rate

the terms are

regardless of the type

This European Standard is applicable to electrical apparatus protected by enclosure and temperature limitation for use in areas where combustible dust may be present in quantities which could lead to a fire or explosion hazard

This document specifies a method of testing the continuous wave (cw) laser resistance of the shaft of a tracheal tube and the cuff regions including the inflation system of tracheal tubes designed to resist ignition by a laser

also called spikes

These methods are typically used where the measurand is expected to be present in very small amounts and concentrations at the limit of detection (LOD)

ii) Clause 8 – Installation planning

hardness and manufacture are stated

4 Number and mass concentrations