Shrink chuck 4,5° with cooling channels HSK 63 - 14 - 160Application: For mounting tools with straight shanks. Note: Toolholders suitable for induction , contact and hot air shrink units. 3, 4, 5 with h4 tolerance and 6 32 with h6 tolerance For 3, 4 and 5 mm only solid carbide tool shanks must be used! All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m

With built-in tightening bolt

B4 - 25 x 16 x 30

Toolholders suitable for induction-

For d = 60 only with four fi xation screws according to DIN 912

shank form UF

break-proof and impact-resistant ABS plastic

Suitable for internal coolant

With clamping screw and O-ring

clamping depth l2 = max

- Especially suitable fore wire EDM

which can cause high frictional forces on the thread flanks

All functional surfaces fine machined