STITCHED OVAL DIE SET - Gina Marie DesignsLargest layer measures approx. 4. 94 x 3. 88 Tips and tricks for die cutting When using steel dies I like to reccomend for machines that need 2 plastic cutting plates to keep one new and use the other to cut into. Make sure you are flipping the one your cutting into to help reduce the wave that will happen with excessive cutting. Keeping one plate new at all times helps the die not need to flex to two plates and only one. I find you typically get a

Keeping one plate new at all times helps the die not need to flex to two plates and only one

Putting it in flush can cause speed bumps on your machines roller and poor cuts in the future

When using steel dies I like to reccomend for machines that need 2 plastic cutting plates to keep one new and use the other to cut into

You dont have to do this but if a die is proving a little more difficult it is good to try this

I find it applies the most pressure from the roller to the blade of the die and not the back of it

That means to run them in by a corner first and not flush into the machine

Largest layer measures 4x5

Beautiful full panel die

Largest measures 4

Make sure you are flipping the one your cutting into to help reduce the wave that will happen with excessive cutting

there is approx an 1/8 space between this die and an a2 card

Largest layer measures 4x4