Plastics and ebonite. Determination of indentation hardness by means of a durometer (Shore hardness)1 Scope 1. 1 This International Standard specifies a method for the determination of the indentation hardness of plastics and ebonite by means of durometers of two types: type A is used for softer materials and type D for harder materials (see the Note to 8. 2). The method permits measurement either of the initial indentation or of the indentation after a specified period of time, or both. NOTE The durometers and the methods specified in this

Transport (air

What is BS 4258-9- Chloride content of phosphoric acid for industrial use about

“Metallic protection” was changed to “Cable protection”

and recording method of the

or who are suffering from atrial fibrillation or deep vein thrombosis

Need for a high level of trust

8 helps you with the determination of the glycerol content of commercial soaps

Measurement of film thickness on rough surfaces

BS EN 10293:2015 supersedes BS EN 10293:2015 which is withdrawn

clarifying that reliability data must be derived from the performance in the operating environment

Locating causes of security and safety alarms

PD 5500:2012 outlines the latest amendments to the specification up to and including those published in September 2011