Bonded abrasive products. Dimensions - Grinding wheels for manually guided grinding1 Scope This part of ISO 603 specifies the nominal dimensions, in millimeters, of: Type 1: Straight grinding wheel Type 5: Wheel recessed on one side Type 6: Straight cup wheel Type 35: Cemented or clamped disc wheel Type 36: Disc wheel with inserted nuts Type 37: Cylinder wheels with inserted nuts These bonded abrasive products are intended to be used for the grinding of any surface and regrinding of workpieces. The workpiece is guided by hand, the

Bicycle designers

to ensure human health and safety as well as protection of the environment

followed by expensive and time-consuming chemical analysis

BS EN 12735-2 exemplifies the required mechanical properties

measured on an ear simulator complying with IEC 60318-1 and in terms of model-specific data given in two additional tables for the IEC 60318-3acoustic coupler and the IEC 60318-1ear simulator

you can be ensured of the properties of corrosion-resistant steel castings

This part specifies the technology-specific implementation of the protocol-specific functionality and communication services

BS EN 2130 specifies the required characteristics

BS EN IEC 60512-23-3 on Connectors for electrical and electronic equipment is applicable to:

their use is restricted to the fulfillment of category 3 requirements

What is BS EN 10341—Steel sheet and strip about

Providers of other information technology