Standard Guide for Testing of Hazardous Materials (Dangerous Goods) Packagings

Note 1: The techniques set out in this standard are also applicable to the management of premises and systems where water is provided from a private supply

NOTE Tests have shown that mould design in an important factor in the reproducible preparation of test specimens

Installation requirements for gas-fired overhead radiant heaters and systems for the environmental heating of premises other than domestic dwellings

temperature and pressure

Prescriptive guidance on methods and applications is not possible

Electricity Grid manufacturers and installers

and associated equipment intended for use in the residential

including identification of the interfaces and the interactions of this system with its subsystems or other systems

NOTE 2 The requirements for the control of warning horns can be found in EN 16186‑2

Annex A (normative) Method for testing CEADS under conditions of arcing due to an internal fault

in compliance with BS EN 62435-2

The method has been additionally validated in several interlaboratory studies