Morse taper adaptor SK 40 - 1 - 50Application: For mounting tools with Morse taper shank and tang according to DIN 228 1 form B. All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m Tensile strength in the core of min. 800 N mm after DIN All functional surfaces fine machined

Horizontal und vertikal aufspannbar

critical factors for successful deep face grooving operations

Positive clamping due to penetration of the hardened claw tips

Collets sealed with seal for IC

With bolted corpus

Minimal length compensation on compression and expansion balances very small pitch differences between synchro spindle and tap

For adaption from SK/ISO to PSC (ISO 7388-1 to ISO 26623-1)

With ball bearing clamping nut

Sealing capacity up to 80 bar

M14 - M30 = 8

Graduation: 0

With retaining screw