Plastics. Polycarbonate (PC) moulding and extrusion materials - Preparation of test specimens and determination of propertiesWhat is this standard about? This document specifies the methods of preparation of test specimens and the test methods to be used in determining the properties of polycarbonate moulding and extrusion materials. Requirements for handling test material and for conditioning both the test material before moulding and the specimens before testing are given in this document. This document gives procedures and conditions for the preparation of test specimens

It also demonstrates some specific outcomes in relation to cybercrime

PSL-2 and PSL-3)

restricted by the other fingers

for example manual call points that are intrinsically safe or for use in hazardous conditions

The second group of three digits identifies the shanks and handles used for instruments and the overall lengths of instruments

ISO/IEC 27001 and ISO/IEC 27002 include a control objective for information security aspects of business continuity management (refer to BS ISO/IEC 27002)

examinations and tests of lift components which are referred to by other standards used for the design of passenger lifts

It can also be used to identify the best selection of test specimens required to cover a wide range of product variations

It does not include requirements for safety devices which incorporate a flame arrestor which are covered by BS EN 730-1

The test method adopted (if Method R2 is used with Epstein strip specimen

BS EN 4536-2  specifies the characteristics of plain bushes in corrosion resisting steel with self-lubricating liner

National Tyre Distributors Association