Standard Specification for Precast Concrete Water and Wastewater Structures

b) the two modes in which those procedures operate

an intermediate set of tests designed to ensure that an instrument remains within the required performance specification

BS EN BS EN 60512-25-4 on the propagation delay of connectors is useful for:

BS QC 750113 specifies the test method and inspection method for detecting whether the requirements are appropriate or not

5 mm thick

the shear rate in the ISO 20844 test method can be too low to generate a realistic permanent loss in viscosity of the fluid

BS 6349-4 gives recommendations and guidance on the design of fendering systems and layouts

— support for the encoding mechanisms defined in ISO/IEC 15962

symbolic display in addition to alpha-numeric capacity

were also consulted during the revision of PAS 43

Oxidized bitumen grades are blown or oxidized asphalt which is produced by passing air through soft bitumen under controlled temperature conditions

Conforming to PD CEN/TS 17118