BeeLink SER7 Mini PC Rack Mount (Modular)3D Printed 2RU rack mount for the BeeLink SER7 Mini PC. This is part of our ModMount Range, so you can mix and match your parts! NOTE: You will need to pair this with another ModMount item (Like 2 Blanking Plates) to make a full 2RU Width, screws are included to join the parts. The Mini PC slides into the frame from the front with cables accessible from the rear. This listing is just for the Rack Mount, other photos showing Blanks etc are just for

3D Printed 1RU rack mount for the Home Assistant Yellow and DFRobot IoT Router Carrier Board

The Mini PCs slide into the frame from the back and are held in place securely by the rear retaining plate

or you can use 2 of these to mount a total of 8 RaspberryPi's together

The device slides into the frame from the front

NOTE: You will need to pair this with another ModMount item (Like a pair of Blanking Plates or another Mac Mini Mount

21mm x 81mm x 117mm (HxWxD)

now in a design to suit 10 Inch Racks

3D Printed 1RU rack mount for the Calix GigaPoint GP1101X GPON Modem

3D Printed 1RU rack mount for the Hubitat C5 / C7 or C8 Hub

3D Printed rack mount that can combine your Unifi Switch 8 150W PoE+ Switch (Model: US‑8‑150W) & Unifi Switch Lite 16 PoE (Model: USW-Lite-16-POE (45W)) into a Single RU

3D Printed 1RU rack mount for 2x Fosi Audio V1

Your Switch slides into the frame from the front and the Rack mounting arms screw into the side of the frame using the supplied screws