Connections for general use and fluid power. Ports and stud ends with ISO 228-1 threads with elastomeric or metal-to-metal sealing - Stud ends for general use only with metal-to-metal sealing (type B)1 Scope This part of ISO 1179 specifies dimensions, performance requirements and test procedures for stud ends with ISO 2281 threads and metal to metal sealing for general use only. These stud ends should not be used for leak free hydraulic fluid power applications. Stud ends in accordance with this part of ISO 1179 may be used at working pressures up to 40 MPa (400 bar) for the S series, up to 25 MPa (250 bar) for the L series, and up to 10 MPa (100

ethical business

It is not applicable to nitrided parts and stainless steels

Other requirements can be found in separate International Standards:

Compression springs

Physical media attachment (PMA) sub-layer

This part of ISO 12219 describes and specifies the whole vehicle test chamber

with additional or modified normative requirements

If you want to ensure continuing compliance and certification to ISO 13485

BS ISO 11413 specifies a method for the preparation of test pieces assembled from polyethylene (PE) pipes or spigot-ended fittings and electrofusion fittings (e

The guidelines in BS EN 60603-7-51 enable you to provide a superior quality product to your customers

Note3: The parameter pulse repetition frequency

and centre-axle trailers) as defined in Annex 7 of the UN-ECE Consolidated Resolution on the Construction of Vehicles (R