Chicago Dryer Compatible Rubberized Ironer Belt, 2″ × 65″ – 1003-040Rubberized Ironer Belt 2" x 65" Heat sealed ends. Clipper laced. Ready to install. Cut to OEM spec and finished in house. Drop in replacement for Chicago Dryer flatwork ironer systems. No measuring, no cutting, no lacing required. Specifications Material Rubberized Width 2 in Length 65" Compatible With Chicago Dryer Lacing Clipper End Treatment Heat Sealed Made In USA DISCLAIMER: All brand names are trademarks of their respective owners. These

r-1tl8opc{font-family:"Segoe UI"

Typical Use Ironer discharge / doffer roll covering

The Dependo 2" Drain Valve [DE26680520] is specifically engineered for commercial laundry systems operating at 120V

this drain valve is designed to ensure effective water management

table linen

Maintenance Tip: Verify pulley groove condition and recheck belt tension after initial run-in to maximize belt life

Cotton Ironer Belt — 4" x 224"

drum misalignment

Chicago Dryer Polyflake Ribbon 2" x 59-1/2" With Pin [1003-118]

Chicago Dryer Lower Jaw Vertical Clamp Assembly Cascade [0204-009]

it's a comprehensive solution for revitalizing your existing actuator

Material: Electronic microprocessor control board assembly