Plastics. Injection moulding of test specimens of thermosetting powder moulding compounds (PMCs) - General principles and moulding of multipurpose test specimens

Why should you use PD CEN/TS 16614-2

Who is BS EN 50090-4-3- Media independent communication over IP for HBES for

BS 3909‑2 and BS 3909‑3

This document specifies safety requirements for

Results of an interlaboratory test

This International Standard specifies a method for the determination of the conductivity of aqueous extracts of paper

NOTE Methods using parallel line gratings and tapered line gratings have been given in the annex for information

the standardized dimensions of which and the characteristics necessary for their application are given below

This document specifies test procedures and equipment which can be used in the evaluation of workwear (including

Who is BS 4582-2 - hobs and cutters specification for

A material's shear strength is defined as its capacity to withstand forces that cause the material's internal structure to move against itself

It is the laboratory’s responsibility to ensure the suitability of this test method for the water samples tested