Holding fixtures of cylindrical abrasive sleeves - Holding fixtures with shank for hand-held grinding machines1 Scope This part of ISO 15637 applies to holding fixtures with shank for use with cylindrical abrasive sleeves with D 100 mm in accordance with ISO 2421. Holding fixtures with shank having a diameter D 100 mm mostly have lamellar cores and are used on hand held grinding machines. The impact of centrifugal forces on the lamellae result in an increase in diameter and thereby clamp the abrasive sleeve on to the holding fixture.

BS EN 61000-4-3:2006+A2:2010 looks at the testing and electrical measurement techniques to ensure protection against radio frequency electromagnetic fields from any source

The results obtained by means of this method have to be interpreted and assessed by persons who are specially trained for this purpose

With obedience and compliance to BS 3531-23

or gas and fuel pumps/pipes to prevent the leakage of gas or liquid

This document is aimed at use by entities other than trust service providers

3 034123-59-6 H Linuron C9H10CI2N2O2 249

Manufacturers and designers of plastics measuring spoons

BS 6907 is based on the International Electrotechnical Commission’s publication IEC 621 “Electrical installations for outdoor sites under heavy conditions (including open-cast mines and quarries)” and

and medical requirements

Design methodology

ISO 3451-4 and ISO 3451-5

PAS 46 looks at how to get reactive and proactive feedback from customers and employees