Link G4X MX5Link MX5NAX ECUThe Link G4X MX5Link MX5NAX ECU is a direct fit engine management system designed for early Mazda MX5 NA and BP engine applications. It installs into the factory ECU location and connects directly to the OEM wiring loom on supported vehicles. This ECU is intended for manual transmission vehicles only and supports most factory systems while providing advanced tuning capability through the G4X platform. Important: Manual transmission only. Designed for

E-Throttle Relay – Aux 12

General sensor mounting using 1/8 NPT threaded sensors

Installation is carried out without modification to the factory wiring loom

Link ECU G5 Voodoo Pro

Pin 8 – Analogue Temperature 3

Free firmware updates supported by ECUMaster

the Razor PDM has been designed with vehicle protection in mind

What it’s used for

Turbocharged or supercharged applications up to 3

Designed for Citroën Saxo VTS three connector ECU applications

16 degree travel (approximately 70 mm)

Lambda sensor connection uses a DTM 6 way connector