Steel products. Employer's qualification system for non-destructive testing (NDT) personnelThis document specifies an employers qualification system for non destructive testing (NDT) personnel performing the testing of the following steel products under the employers responsibility: a) tubes pipes (seamless or welded); b) flat products, long products, rails, bars, sections, rods and wires. This document specifies qualification requirements for the competence of Level 1 and Level 2 NDT personnel to execute specific tasks in the NDT of steel

BS EN 16931-4 facilitate Straight Through Processing by the key actors in the supply chain (Buyers

This document does not cover the dialysis fluid that is used to clinically dialyse patients

These are the general conditions unless otherwise stated in the corresponding test method

This third amendment deals with concerns raised by national committees during the preparation of Amendment 2 to include a specific type of interconnection monitoring not covered in the previous editions

5 Hz to 80 Hz

BS EN 1563 helps identify the specific grades of spheroidal graphite cast irons in order to ensure improved machinability

Introduction of a clear distinction between ingots and castings about pressure equipment applications in the whole standard

BS ISO 16428:2005 specifies standard environmental conditions for the testing of metallic materials intended for implantation

As a quality control personnel

natural disasters such as earthquakes and flooding

Hazards related to energy supply disconnection

the picture parameter set references a sequence parameter set that contains sequence level decoding parameter information