Method for the determination of C3A in the clinker from cement analysis1 Scope This document describes the analytical procedures used to determine the content of C3A in the clinker starting from a chemical analysis on cement. The method can be applied to CEM type I and IV for the determination of the requirement of C3A, as defined on EN 1971. This document describes two methods, traditional wet and XRF analysis (EN 1962), which can be considered to be equivalent, in the scope of this CEN TR 17365, for the determination

audio and video segments

The objective of this Technical Specification is to establish a procedure to be used by rail transport authorities and/or radio suppliers to determine the appropriate performance requirements of radio system for a radio-based train control system

supply current

BS AU 237a describes the design and performance of battery clips

BS EN ISO 14006 incorporates the necessary information from the other International Standards

To promote the further development of HITU and to ensure its safe and effective use

long term post excavation storage or excavations under water

BS ISO/IEC 27000:2009 Information technology

and integrated circuits for corrosion protection

Material efficiency

This document specifies a test method by artificial perspiration solution aqueous extraction for the determination of the aqueous extractable content of the following preservative agents in leather by liquid chromatography:

The character set is intended for use with the Old Slavonic language