Steels for the reinforcement of concrete. Reinforcement couplers. Requirements and test methods1 Scope This British Standard specifies requirements and test methods for steel reinforcement couplers (hereafter called couplers) to be used for the mechanical splicing of steel reinforcing bars. It specifies requirements for couplers to be used for mechanical splices in reinforced concrete structures under predominantly static loads and additional requirements for couplers to be used in elements of structures subject to high cycle elastic fatigue

5 Write data by identifier (2E hex) service

Specifically the values in Table NA1 were updated to be consistent with Highways Agency standard BD 60/04

1 Relationship between magnetostriction and magnetic domain structure

BS EN 16212:2012 provides a general approach for energy efficiency and energy savings calculations with top-down and bottom-up methods

If there are different producers

These requirements could also correspond to the requirements for measuring current transformers

Ignition source control

Single particle analysis in the scanning force microscope

This standard is applicable to automotive LPG for use in LPG engine vehicles designed to run on automotive LPG

harmonized provisions

Requirements for environmental testing of electrotechnical products

the form and strength in Braille as an aid to identification for blind and partially sighted people