Metallic materials. Tube ring hydraulic pressure test1 Scope This document specifies the ring hydraulic pressure test for metallic tubes. It is generally applied to tubes with an outside diameter greater than 120 mm and outside diameter to thickness ratio of not less than 20. The objective of this test is to ascertain the value of the hoop stress required to produce a specified total circumferential (hoop) strain.

4 Basic requirements

including the terms to be used

BS EN 14161:2003 supersedes BS 8010-1:1989

Capacitors for the suppression of radio interference

Who is BS IEC 62047‑31 - Micro-electromechanical systems (MEMS) materials for

hereafter referred to as "appliances"

It does not apply to materials which exhibit inhibitory effects on the test microorganisms at the concentration chosen for the test

The use of specified dry sand infill to the sections may be used as an alternative to concrete

2) premises where goods may not necessarily be sold over the counter but in which a trade or business is carried out

The castings may be manufactured by the sand

A derrick is used for moving materials vertically and horizontally

This International Standard specifies a method for the determination of sediment in crude petroleum and fuel oils by extraction with toluene