Vehicle security - Specification for locking systems for goods vehicle driver's compartmentsBS AU 209 7: 1993 specifies requirements for the performance of locking systems fitted to all closures through which access may be gained to the drivers compartment of goods vehicles. Goods carrying compartments which are not accessible from the drivers compartment, are the subject of Part 8 of this British Standard. This Part of BS AU 209 does not apply to category N. 1 (gross vehicle mass of up to 3. 5 t) vehicles that have been derived from

Manufacturers of evacuation alert systems

Diagonal rigidity

thorough examination (including testing)

The use of a systematic approach to managing innovation is a good stepping stone for any organization aiming to become more innovative

BS EN ISO 12162 is an International Standard which establishes the classification of thermoplastics materials in pipe form and specifies the material designation

Air cleaners

The vapor is generated by heating a fluid often called e-liquid

Durability of materials

ISO 8434-1 is the first part of the ISO 8434 series of documents that specifies the general and dimensional requirements for 24° cone connectors using the cutting ring and O‑ring seal cone (referred to as DKO) suitable for use with ferrous and non-ferrous tubes with outside diameters from 4 mm to 42 mm inclusive

An ISIL identifies an organization

The management system specified ISO 39001 focuses the organization on its RTS objectives and RTS targets and guides the planning of activities that will realize these goals by using a Safe System approach to RTS

of which it constitutes a minor revision following the publication of ISO 17668 with the following changes: