H2010L Steel Helical GearBoston Gears stock helical gears are manufactured in both right and left handed configurations with an industry standard 45 helix angle to transmit motion and power between non intersecting shafts that are parallel or at 90 to each other. For parallel shaft operation, helical gears with opposite hand helix angles are required. For shafts at 90, a same hand helix angles must be used. For parallel shaft applications, the overlapping tooth contact of our

Material: Cast Iron

It is a high grade

it’s important to keep the ratio as low as possible

Click here for spec sheet: SAPA Spec Sheet

Miter Gears are similar to Bevel Gears except Miter Gears are used for 1:1 ratios

Can be mounted vertically or horizontally

having good hardness

Click here for spec sheets: Stand Off Catalog

Spiral Angle: 35 Degrees

A shifting of the valve changes direction–even when the air motor is running full open

Boston Gear’s stem pinions feature small numbers of teeth that are cut integral to the steel shaft

Material: Molded Delrin