Designjet T1300 Formatter Board w/hd | Fast DeliveryEasy Printer Fix updated 11 05 24 The formatter board has either a network cable or USB cable plugged into it. Next to the connector there are 3 LEDS on the formatter board. They are labeled I, II, III. They will either be solid or flashing. You need to determine what the sequence of the three LEDS are in order to decode the error. Here are the most common errors. This LED sequence points to a faulty Hard Disk: LED1: FLASHING LED2: OFF LED3: OFF

The formatter serves as the brain of the printer

Various issues can cause a carriage error

setup poster

This feature enhances productivity and flexibility

You might need to have the printer serviced or repaired if it is a hardware fault that cannot be resolved through basic troubleshooting

The formatter is a critical component of any printer

I will follow up with tracking information when deposit has been received

writing or initializing the EEROM failed

Large Format Printing: It can print documents up to 36 inches wide

all factory sealed T and Z series formatters are sold 'As Is'

The Electronics Module is requesting a move to the Service Station while the previous move is still being completed

Storing these resources locally helps improve printing efficiency by reducing the need to resend them with each print job