Cutter arbors with tenon drive - Dimensions of 7/24 taper1 Scope This part of ISO 3937 specifies the dimensions of cutter arbors with tenon drive with 7 24 tapers. It also specifies the dimensions of cutter arbors with tenon drive and enlarged contact surface of the cutters. The interchangeability dimensions of the milling cutter bearing on the cutter arbor are in conformity with ISO 2780. The dimensions of the retaining screw used are specified in ISO 2780. 7 24 tapers are in conformance with ISO 297 for

Contents of BS EN ISO 17510-1:

Those responsible for policy

The front page of BS 9220 contains as a minimum the information required by BS 9220

petrol stations

The amendment adds requirements for legacy software which will help manufacturers demonstrate compliance with the relevant European Directives

Chemical composition was changed for the following grades: austenitic grade 1

13 ALARM AND EVENT SERVICES

the optical delivery system and the devices for shielding and assist gases

BS 5350-C15 describes a procedure for determining the bond strength of a double lap joint by subjecting the test piece to a compressive force

The following are outside the scope of this standard:

adopting the guidelines of BS 5131-5

Who is DD IEC/TS 62215-2 - Immunity of integrated circuits for