SNASPA204-12 L3 Standard Duty Stainless Steel Eccentric Locking Tapped Base Pillow Block BearingClick here for spec sheets: SUCSPA Spec Sheet Note: This is the spec sheet for the set screw Locking version, the SNASPA has an eccentric locking bearing insert

Porous flanged bronze bearing is press-fit in sturdy zinc die cast sphere with felt strip for lubrication

self-centering design for use in through-bored components with high torque and/or bending requirements

non-self-centering design for use in counter-bored components

Double-taper

Click here for spec sheet: NANFL Spec Sheet

Effective on both hard and soft shafts

Allows you room to re-bore the ID without damaging the clamp screws

medium taper

Two-Piece Housing has rust-proof plated finish

oil resistant rubber liner which corrects up to 2° misalignment while reducing vibration & noise

Easily installed where major disassembly would otherwise be required

see SNA vs SUC pages for bearing insert dimensions)