End mill holder Weldon with cooling channels SK 50 - 14 - 100Application: For mounting straight shank tools with lateral flat according to DIN 1835 form B (Weldon). Delivery: With clamping screw and O ring All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m Tensile strength in the core of min. 800 N mm after DIN All functional surfaces fine machined

For machines with rigid tapping

With drivers

Only nominal size d can be clamped (applicable up to 120 bar)

Improves chip evacuation and decreases the risk for chip jamming

For mounting straight-shank tools in collet chucks KPS-system

Collets sealed with seal for IC

With clamping screw and O-ring

clamping depth l2 = max

For mounting straight-shank tools in collet chucks DIN 6391

With clamping screw

with IC DIN 6499 B (ISO 15488 B)ER-system

High flexibility: Large holding capacity up to –1 mm