End mill holder Whistle-Notch HSK 100 - 40 - 120Application: For mounting straight shank tools and inclined flat according to DIN 1835 form E (Whistle Notch). Delivery: With clamping screw and axial adjustment bolt All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m Tensile strength in the core of min. 800 N mm after DIN All functional surfaces fine

Hardening depth 0

With wrench

With ball bearing clamping nut All holders are made of forged steel

Delivery: without inserts

From DCONWS = 25 on two clamping screws

SK 30 without coolant exit bores on the end faceDelivery:

a clip and can be moved in steps of 25 mm

Suitable for internal coolant

The insert is clicked into our grid system with

The tapered tool holder is thus optimally

Minimal length compensation on compression and expansion balances very small pitch differences between synchro spindle and tap

thin thread and pitch diameter oversize