GH2C-081-SS Two Piece Clamping Shaft CollarEasily installed where major disassembly would otherwise be required. Design fully engages the shaft without marring. Recessed screw head provides safety with an outside surface free of major projections. Provides greater axial holding power than set screw or one piece clamping collars. Effective on both hard and soft shafts. View Catalog Page

Tolerates -5° to 220° F

View Catalog Page

oil resistant rubber liner which corrects up to 2° misalignment while reducing vibration & noise

Provides greater axial holding power than set screw collars

Porous flanged bronze bearing is press-fit in sturdy zinc die cast sphere with felt strip for lubrication

Provides torque transmission & alignment

Traditional cost effective rigid coupling design

Provides greater axial holding power than set screw or one-piece clamping collars

Includes 2 rubber grommets to reduce vibration & noise

Can be mounted vertically or horizontally

Two-Piece Housing has rust-proof plated finish

Ball Bearing Type