Receiver Rack Mount Kits - MIPROThese accessories are used to mount MIPRO wireless mic receivers into a 19" rack. The FB 71 mounts one half width receiver, the FB7 2 kit mounts two receivers side by side. All screws and hardware required to fit to the receiver are supplied with the kit. The FBC7 1 cables (supplied as a pair) allow you to extend one receiver aerials out onto the FB 71 or FB 72 brackets.

The PEEK diaphragm material offers a smooth frequency response out to 20kHz making this driver very nice for all sound system and hi-fi applications

(Note the MRM-72B cannot be fitted if the MTM-92 wireless interlink module is fitted)

45 watt RMS

Use on a table top or mount onto MS-70 speaker stand

Mounting holes on 245mm dia circle

Panel cutout 70mm dia (not allowing for the connector tabs)

Connection via Faston connectors or solder

Thiele-Small parameters are available for new build enclosure design

Audio Inputs: Mic in 1/4" (6

Closed back headphones with solid construction and a big sound

Standard 4x M6 bolt holes on a 76mm diameter circle that will match with SB Audience and other compression drivers

To line up with the mounting hole slots of your rack mount equipment