Shrink chuck 4,5° SK 50 - 10 - 120Application: For mounting tools with straight shanks. Note: Toolholders suitable for induction , contact and hot air shrink units. 3, 4, 5 with h4 tolerance and 6 32 with h6 tolerance For 3, 4 and 5 mm only solid carbide tool shanks must be used! All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m

Slides hardened and grinded

Perforated plate for mounting accessories

E2= 10 pieces

Ground on the inside and outside

Powder-coated

All collets with outside form DIN 6388 (ISO 10897) can be clamped

There is no need to set the zero position each time the caliper is used as the origin setting is retained even when the caliper is switched off

With balanced clamping nut All holders are made of forged steel

- Especially suitable fore wire EDM

Minimum internal diameter measurement capability of 20mm

reading parts brushed chromium-plated

4 coupling