Smoke and heat control systems - Smoke ducts sections1 Scope This document applies to smoke control duct sections placed on the market and intended to operate as part of a pressure differential system or smoke and heat exhaust system. This document specifies requirements and gives reference to the test methods defined for smoke control duct sections and their associated components (for example, hangers and other items proven at the time of testing), which are intended to be installed in such systems in

It applies to paper and board

10 Provision against electrolyte hazards

BS EN 60627:2015 supersedes BS EN 60627:2001

Manufacturers of ductwork components

What is BS EN 13060- Small steam sterilizers about

in particular BS EN ISO 1101 on geometrical tolerancing and BS EN ISO 5459 on datums

Procedures for training of condition monitoring and diagnostics personnel are specified

junctions of ceiling materials

which means it is stiff and will break if bent

BS EN 490 specifies requirements for concrete roofing tiles and fittings for pitched roof coverings and wall cladding and lining

NOTE Phantom manufacturers are encouraged to extend the frequency range to which phantoms are specified to enable relative depth-of-penetration tests of systems operating at fundamental and harmonic frequencies above 17 MHz

and is intended to be used as a supplement to the regulations for fuel oil