Shrink chuck 4,5° HSK 100 - 10 - 200Application: For mounting tools with straight shanks. Note: Toolholders suitable for induction , contact and hot air shrink units. 3, 4, 5 with h4 tolerance and 6 32 with h6 tolerance For 3, 4 and 5 mm only solid carbide tool shanks must be used! All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m

5-30mm and 25-50mm range are supplied with setting rings

sleeves and tool arbors

- Double-clamping via two mobile and one fixed jaw

The steel body is hardened and grinded all-round

For the storage of collet chuck

Measuring surfaces allow for the measurement of external diameters

in conjunction with „KEMMLER Precision collet chuck ER"

LSCX = Clamping depth

Exchangeable carbide tipped scriber

Wherever reduced interference contours are required

Resolution:

thin thread and pitch diameter oversize